Usually one of four causes: the suction field does not reach the whole slab, a second foundation type was never treated, leakage is stealing the fan's suction, or the retest ran under unusual conditions. Each is diagnosable and fixable.
More detail
Start by checking the manometer against its startup mark; weak suction points at the fan or a blockage, strong suction with a high retest points at coverage. Coverage gaps are the classic metro case: tight clay or a buried footing divides the sub-slab space, and the cure is a second suction point, which a follow-up communication test locates precisely rather than by guesswork. The second classic is the untreated zone, the crawl under the 1970s addition or the slab wing of a split-level, contributing gas while the basement system runs flawlessly; the fix extends the system, often off the same fan. Leakage cases show up as a fan moving plenty of air with little pressure field, and resealing the floor-wall joint, sump lid, or an overlooked opening restores the margin. Retest conditions deserve one honest look too: a test run with a door propped or during a storm can read oddly in either direction. Bring the numbers, before, after, and the gauge reading, to a repair assessment; the diagnosis usually takes one visit.